Four Methods of Temperature Control for Organic Fertilizer Drying Equipment

The drying efficiency of drying equipment in organic fertilizer production line is more important to the firing temperature. The change of firing temperature directly affects the drying quality, energy consumption and refractory brick life, so it is very important to strictly control the firing temperature.

But we will find that the firing temperature will always change.
If the firing temperature becomes lower, the feeding amount of the dryer should be adjusted to reduce the material. The range of reduction is based on the predicted range of temperature reduction. According to the variation of the feeding amount and the situation in the dryer, the corresponding air and coal consumption should be adjusted in time.

When the firing temperature becomes higher and the feed rate is at a higher level, the coal should be reduced first. The extent of reduction depends on the temperature of the industrial dryer has increased, rather than rush to feed. Only to find out the reasons for the change of the firing temperature of the drying equipment, and solve it pertinently. In addition, timely report to the superior in case of any change of temperature.

(1) Sealing control of dryer. It can be partially sealed, integrally sealed or closed chamber, etc., and the dust producing point can be sealed with a sealing cover, which can greatly reduce the material scattering and dust.

(2) Eliminate the height potential energy difference of dryer. This is the main reason of dust spilling. The elimination of height potential energy difference is caused by powder drop of hopper, protective cover and chute of handling equipment. We should try our best to reduce the fall and the inclination angle of the chute. Some airtight chambers are better to cause negative pressure, which is conducive to the collection of dust.

(3) The transportation equipment with good sealing performance shall be used to reduce the height difference and inclination angle of discharge material flow, and the flow separation facilities shall be set as far as possible. It can not only enhance the configuration flexibility and efficiency of each operation room, but also reduce the scattering and dust.

(4) Use the exhaust system. In order not to let the dust bring more pollution, we can also remove the indoor dust through the exhaust system, that is to remove the indoor exhaust gas.

Fertilizer Drying Equipment For Sale:

Leave a Reply

Your email address will not be published. Required fields are marked *